How to Use the LD Motor Driver – Arduino Tutorial: The LD is a pin Motor Driver IC which can control a set of two DC motors simultaneously in any. SunFounder LD is a monolithic integrated, high voltage, high current, 4- channel driver. Basically this means using this chip you can use DC. The Motor Driver is a module for motors that allows you to control the working speed and direction of two motors Motor Driver is designed .
|Published (Last):||28 October 2004|
|PDF File Size:||1.1 Mb|
|ePub File Size:||1.4 Mb|
|Price:||Free* [*Free Regsitration Required]|
SunFounder LD is a monolithic integrated, high voltage, high current, 4-channel driver.
LD Motor Driver Shield – Wiki
Basically this means using this chip you can use DC motors and power supplies of up to 16 Volts, thats some pretty big motors and the chip can supply a maximum current of mA per channel, the LD chip is also what’s known as a type of H-Bridge.
The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e. The schematic diagram is as follows: The LD is quadruple high-current half-H drivers. It is designed to provide bidirectional drive currents of up to mA at voltages from 4.
All inputs are TTL compatible. Each output is a complete totem-pole drive circuit, with a Darlington transistor sink and a pseudo- Darlington source. Drivers are enabled in pairs, with drivers 1 and 2 enabled by 1,2EN and drivers 3 and 4 enabled by 3,4EN. When an enable input is high, the associated drivers are enabled, and their drievr are active and in phase with their inputs.
When the enable input is low, those drivers are disabled, and their outputs are off and in the high-impedance state. Mofor the proper data inputs, each pair of drivers forms a full-H or bridge reversible drive suitable for solenoid or motor applications.
Retrieved from ” http: Navigation menu Personal tools Log in.
DC MOTOR STEPPER MOTOR DRIVER BOARD with LD IC
Views Read View source View history. Navigation Main page Random page Recent changes.
On the rising edge, the data in shift register moves successively one bit i. While on the falling edge, the data in shift register remain unchanged.
Time sequence input of storage register. On the rising edge, data in the shift register moves into memory register.