68HC12 Datasheet, 68HC12 PDF, 68HC12 Data sheet, 68HC12 manual, 68HC12 pdf, 68HC12, datenblatt, Electronics 68HC12, alldatasheet, free, datasheet. 68HC12 Datasheet PDF Download – MC68HC12, 68HC12 data sheet. 68HC12 Motorola datasheet pdf data sheet FREE Datasheets (data sheet) search for integrated circuits (ic), semiconductors and other electronic components.
|Published (Last):||3 December 2017|
|PDF File Size:||4.12 Mb|
|ePub File Size:||12.26 Mb|
|Price:||Free* [*Free Regsitration Required]|
(Datasheet) 68HC12 pdf – MC68HCDG/D 68HCDG 68HC12DG Advanc MC68HC12 (1-page)
The XIRQ input provides a means of requesting a nonmaskable interrupt. During reset, the X bit in the condition code.
Because the XIRQ input is level sensitive, it can be connected. This pin is always an input and. There is an active pull-up on this pin while in reset. The pull-up can be turned off by clearing. XIRQ is often used as a power loss detect.
If the interrupt line is held low, the. MCU will recognize another interrupt as soon as the interrupt mask bit in. The state of these pins during reset determine the MCU operating mode. MODB have active pull-downs during reset. The BKGD pin receives and transmits serial background debugging.
A special self-timing protocol datssheet used.
68HC12 Datasheet(PDF) – Motorola, Inc
The BKGD pin has an. This pin is always an input and can always be read. There is an active pull-up on this pin while in reset and immediately out of reset.
XIRQ is often used as a power loss detect datasheeh. Whenever XIRQ or IRQ are used with multiple interrupt sources IRQ must be configured for level-sensitive operation if there is more than one source of IRQ interrupteach source must drive the interrupt input with an open-drain type of driver to avoid contention between outputs.
There must also be an interlock mechanism at each interrupt source so that the source holds the interrupt line low until the MCU recognizes and acknowledges the interrupt request. If the interrupt line is held low, the MCU will satasheet another interrupt as soon as the interrupt mask bit in the MCU is cleared normally upon return from an interrupt.
Refer to Development Support. Home – IC Supply – Link.